Skip to content

Low Power Mode

Configuring low power mode will add a separate reporting interval which will only activate when your telemetry device's battery level falls below a specified value. After your battery charges to a level above your low power mode value your station will resume reporting at it's regular reporting interval. Note that only Stevens eTracker and Stevens AVO devices support low power mode.

Steps to Configure Low Power Mode

  1. Navigate to the Station Setup page for the station you would like to configure low power mode for and select 'Configuration' from the side menu.

  2. Scroll down to the card titled 'Low Power Mode' and click the button that says 'Turn on low power mode'.

  3. Enter the voltage value that you would like low power mode to activate at. 10 volts is the recommended low power setting but valid values are 1V - 14V.

  4. Next select a reporting interval for low power mode from the dropdown menu.

  5. Click the 'Save' button to finish. When your battery voltage falls below the value you set, your device will now report at the interval that you set for low power mode.